Computers and Technology, 06.09.2019 16:10 rachel8926

We consider the do-178c standard, which enforces compliance between the applicable airworthiness regulations, and the software aspects of airborne systems. ( note that this replaces the older do-178b standard.)
we should consider the following aspects:
i. what procedures does the standard enforce during the production of software?
ii. describe the different levels within the do-178c, describing the categories of failure conditions?
iii. how does the standard enforce "traceability" (the defined relationship between requirements and software components)?
iv. what other standards or procedures are used to enforce safety?

Answers: 2

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 08:10

Technician a says that if a valve is open when a piston rises to the very top of a cylinder, the piston may actually strike the valve head and cause serious engine damage. technician b says if the camshaft is located in the engine block, then the engine is called an overhead valve engine, ohv engine, or an in-block camshaft. who is right? a. b only b. both a and b c. a only d. neither a nor b

Answers: 3

Answer

Computers and Technology, 22.06.2019 23:20

How can you tell if someone sent you a text message to your email instead of a email

Answers: 1

Answer

Computers and Technology, 23.06.2019 06:00

When is a chart legend used a. all the time b. whenever you are comparing data that is the same c. whenever you are comparing multiple sets of data d. only for hand-drawn charts

Answers: 2

Answer

Computers and Technology, 23.06.2019 12:00

Which of these is an example of an integrated presentation? a. a table created in powerpoint b. an image pasted into powerpoint c. a caption created in powerpoint d. an excel chart pasted into powerpoint

Answers: 1

Answer

You know the right answer?

We consider the do-178c standard, which enforces compliance between the applicable airworthiness reg...

Questions