Auser complains that he cannot access a particular website, although he is able to access other websites. at which layer of the osi model should you begin troubleshooting this problem

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Given a link with a maximum transmission rate of 32.8 mbps. only two computers, x and y, wish to transmit starting at time t = 0 seconds. computer x sends filex (4 mib) and computer y sends filey (244 kib), both starting at time t = 0. statistical multiplexing is used, with details as follows packet payload size = 1000 bytes packet header size = 24 bytes (overhead) ignore processing and queueing delays assume partial packets (packets consisting of less than 1000 bytes of data) are padded so that they are the same size as full packets. assume continuous alternating-packet transmission. computer x gets the transmission medium first. at what time (t = ? ) would filey finish transmitting? give answer in milliseconds, without units, and round to one decimal places (e.g. for an answer of 0.013777 seconds you would enter "13.8" without the quotes)

Guys do you know sh27 cause he hacked me : ( pidgegunderson my old user