Part One: Research the Energy Skate Park Basics: Intro Simulation Instructions: Select the Intro Simulation located at the bottom of the simulation window. Once the Intro Simulation loads, select all of the following from the options located on the right-hand side of your screen: U-shaped ramp Pie Chart Bar Graph Grid Speed Leave the mass on the center setting Then, drag your skater onto the highest part of the U-shaped ramp and select the start arrow to begin. You may use the pause button to stop your skater and the slow motion button to slow the skater down. Record your data in the chart below using the following terms: increases, decreases, or stays the same. Be sure to complete the entire data chart. Position of the Skater on the U-shaped Ramp Amount of Potential Energy Amount of Kinetic Energy Speed Total Energy 1 Moving down the ramp from 6 meters to 4 meters 2 Moving down the ramp from 4 meters to 2 meters 3 Moving up the ramp from 2 meters to 4 meters 4 Moving up the ramp from 4 meters to 6 meters Complete the questions below. Please write in complete sentences. What is the relationship between potential energy, kinetic energy, and speed as the skater moves down and up the U-shaped ramp? What happens to the total energy as the skater moves down and up the U-shaped ramp? Part Two: Design and Test a Skate Park Ramp: Playground Simulation In Part Two, you will apply the engineering design process to design your own skate park ramp. Instructions: Select the Playground Simulation at the bottom of the simulation window. Once the Playground Simulation loads, select all of the following options located on the right-hand side of your screen: Pie Chart Bar Graph Grid Speed Leave mass on the center setting Set friction to none Complete the Hypothesis, Design, Testing, and Conclusion sections below. Hypothesis: In this section, include the if/then statement for your lab. This statement reflects your predicted outcome for the investigation. With the grid selection on,