Chemistry, 26.02.2021 22:40 SmokeyRN

These supplies are needed: distilled water
0.1 M HCl (8.3 mL concentrated HCl per 1 L of solution)
CAUTION: WEAR GOGGLES! HANDLE CONCENTRATED ACIDS UNDER ADULT SUPERVISION IN AN AREA WITH ADEQUATE VENTILATION. ALWAYS ADD ACID TO THE PRE-MEASURED WATER.
0.001 M HCl (1 mL 0.1 M HCl per 100 mL of solution)
0.00001 M HCl (1 mL 0.001 M HCl per 100 mL of solution)
marble, limestone, or chalk chips
pipette (glass with suction bulb or disposable)
4 test tubes
goggles
Follow these directions and complete the activities.

Set up four test tubes in a rack.
Add a small marble chip to each of the test tubes.
Add 1 mL samples of acid solutions as labeled in the chart.
Start with the weakest solution (distilled water) and work your way up in concentration. In this manner, you may use a single pipette for the entire experiment. Each test solution will simply increase the density of ions added to the chalk. Can you understand why you cannot return to a weaker solution with the same pipette?
Observe whether reaction takes place and how fast. Record your results.
Pour the acid solution from each test tube into the sink.
Rinse the marble chips with water and place them in a container for this purpose to be used again.
Observations:

Data Table:

distilled water 0.0001M HCl 0.001 M HCl 0.1 M HCl
strength of reaction
speed of reaction
Analysis:

Marble is made from limestone under the influence of heat and pressure. The chemical formula for limestone or marble chips is CaCO3. When you added the chips to the acid solutions, they effervesced (bubble or foam).

What is the gas that is produced?
What is the chemical formula of the gas?
How could you test rocks for the presence of limestone?
Write a balanced symbol model for the reaction of limestone with hydrochloric acid.

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 23.06.2019 01:30

Ascientist conducted an experiment and discovered that certain plants grow faster when given a particular amount of fertilizer. anouther scientist conducted the same experiment and got similar results. which concept does this best illustrate? a) repetition b) replication c) precision d) validity

Answers: 2

Answer

Chemistry, 23.06.2019 07:00

Under what conditions will a gas be most likely to exhibit the ideal gas properties predicted by the ideal gas law? 1)high pressures and high temperature, because particles are forced closer together with higher kinetic energy, so intermolecular forces of attraction are weaker 2)high pressure and low temperature, because particles are forced closer together and moving slower, so the volume of the particles is less significant 3) low pressure and high temperature, because particles are spread farther apart and moving faster, so the intermolecular forces of attraction are weaker 4)low pressure and low temperature, because particles are spread farther apart with lower kinetic energy, so the volume of the particles is less significant

Answers: 2

Answer

Chemistry, 23.06.2019 08:30

Imagine you are a business executive who wants to pursue an environment policy for your company that limits pollution and uses fewer raw materials but would cost more what might be the discussion to your next broad meeting how would you make your case to your shareholders

Answers: 1

Answer

Chemistry, 23.06.2019 10:30

Which of the following characteristics are true of enzymes? check all that apply. a.)the structure of an enzyme can change if conditions change. b.)a single enzyme can normally catalyze a wide variety of reactions under many conditions. c.)enzymes are found only in nonliving systems. d.)enzymes allow living things to regulate body conditions through feedback mechanisms. e.)enzymes bind to specific substrates in specific ways. f.)enzymes increase the rate of reaction. g.)when shown in energy-reaction diagrams, enzymes represent the higher activation energy.

Answers: 1

Answer

You know the right answer?

These supplies are needed: distilled water
0.1 M HCl (8.3 mL concentrated HCl per 1 L of solu...

Questions