Chemistry, 10.02.2021 21:50 catherineguyen3216

Time (y) 15
1-
15 During a lab investigation, students added four 50 g masses to two boxes and arranged
the boxes so that they were motionless on a pulley, as shown in the diagram. The
students then followed the procedure described in the box. The students recorded their
observations after each procedure and reset the pulley system to the original conditions.
During which procedures did students observe an unbalanced upward force on Box 1?
1
Choose only one.
Procedures
A. Procedures only
B. Procedures 1, 2, and 3
50 g
mass
1. Push Box 1 downward. Observe. Reset.
2. Add another mass to Box 1. Observe. Reset.
3. Remove one mass from Box 2. Observe. Reset.
4. Add another-mass to Box 2. Observe. Reset.
5. Remove two masses from Box 1. Observe. Reset.
C. Procedures 4 and 5
Box 1
D. Procedures 3 and 4
E. Procedures 1, 3, and 5
Box 2

Time (y)

15
1-
15 During a lab investigation, students added four 50 g masses to two boxes and ar

Answers: 3

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 12:00

From the options provided for each element below, choose the properties that it may have based on its location in the periodic table fluorine (f): highly reactive nonmetal shiny a conductor

Answers: 1

Answer

Chemistry, 22.06.2019 22:30

Gusing the milligrams of ascorbic acid you entered above, the ratio of total sample volume to aliquot volume, and the total milligrams of the vitamin c tablet that you dissolved, calculate the mass of ascorbic acid in the vitamin c tablet for each trial. do this by scaling up to find the amount (mg) of ascorbic acid in your 250 ml flask. enter your calculated mass of ascorbic acid in the vitamin c tablet, for each trial. be sure to enter your calculated mass in the corresponding order that you entered your milligrams of ascorbic acid. the milligrams of ascorbic acid you entered for entry #1 previously should correspond to the mass of ascorbic acid that you enter for entry #1 here.

Answers: 1

Answer

Chemistry, 23.06.2019 00:30

You are attempting to recrystallize a crude product mixture. you add the appropriate amount of hot solvent and are allowing the solution to slowly cool to room temperature. however, at room temperature no crystals have appeared, which of the following methods should be used to induce crystallization? choose all correct answers. a) place the flask in an ice bath. b) swirl the contents of the flask. c) add a small seed crystal of the desired product. d) scratch the inside of the glassware using a stir rod. it can be multiple choices

Answers: 3

Answer

Chemistry, 23.06.2019 03:00

Select the correct answer. wax is a nonpolar substance. in which type of substance is it most soluble?

Answers: 2

Answer

You know the right answer?

Time (y) 15
1-
15 During a lab investigation, students added four 50 g masses to two bo...

Questions