A solution of malonic acid, H2C3H2O4, was standardized by titration with 0.0990 M NaOH solution. If 20.52 mL mL of the NaOH solution is required to neutralize completely 11.13 mL of the malonic acid solution, what is the molarity of the malonic acid solution

0.0913 M

Explanation:

We'll begin by writing the balanced equation for the reaction.

This is given below:

H2C3H2O4 + 2NaOH —> C3H2Na2O4 + 2H2O

From the balanced equation above, we obtained the following:

The mole ratio of the acid (nA) = 1

The mole ratio of the base (nB) = 2

Data obtained from the question include:

Molarity of base, NaOH (Mb) = 0.0990 M

Volume of base, NaOH (Vb) = 20.52 mL

Volume of acid, H2C3H2O4 (Va) = 11.13 mL

Molarity of acid, H2C3H2O4 (Ma) =..?

The molarity of the acid, H2C3H2O4 can be obtained as follow:

MaVa/MbVb = nA/nB

Ma x 11.13 / 0.0990 x 20.52 = 1/2

Cross multiply

Ma x 11.13 x 2 = 0.0990 x 20.52 x 1

Divide both side by 11.13 x 2

Ma = (0.0990 x 20.52)/ (11.13 x 2)

Ma = 0.0913 M

Therefore, the molarity of malonic acid, H2C3H2O4 solution is 0.0913 M

what are the two models

explanation:

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.