subject
Chemistry, 21.02.2020 01:57 bri1334

One mole of tungsten (6.02 × 1023 atoms) has a mass of 184 g, and its density is 19.3 g/cm3 , so the center-to-center distance between atoms is 2.51 × 10−10 m. You have a long, thin bar of tungsten, 2.9 m long, with a square cross section, 0.16 cm on a side. You hang the rod vertically and attach a 425 kg mass to the bottom, and you observe that the bar becomes 1.47 cm longer. From these measurements, it is possible to determine the stiffness of one interatomic bond in tungsten. Use g = 9.8 m/s 2 throughout this problem. What is the spring stiffness of the entire wire, considered as a single macroscopic (large

ansver
Answers: 1

Another question on Chemistry

question
Chemistry, 22.06.2019 00:00
What is the result of multiplying (2.5 × 1010) × (2.0 × 10-7)? a. 5.0 × 103 b. 5.0 × 10-3 c. 5.0 × 1017 d. 5.0 × 10-17
Answers: 1
question
Chemistry, 22.06.2019 08:30
Agroup of students is studying convection current. they fill two identical balloons with the same amount of helium. one balloon is placed in a freezer and the other is in an area with warm air. after 10 minutes, the balloon are released from a height of 1 meter. which of the following to the students most likely observe? a) the warm balloon expands and rises. the cold balloon shrinks and sinks b) the balloon both rise. the cold balloon is larger than the warm balloon c) the cold balloon expands and rises. the warm balloon shrinks and sinks d) the balloon rise at the same rate. both balloons are the same size
Answers: 1
question
Chemistry, 22.06.2019 11:00
What is the temperature of 0.750 mol of a gas stored in a 6,850 ml cylinder at 2.21 atm? . 2.95 k 5.24 k 138 k 246 k
Answers: 3
question
Chemistry, 22.06.2019 17:10
)benzene and toluene form nearly ideal solutions. consider an equimolar solution of benzene and toluene. at 20 °c the vapour pressures of pure benzene and toluene are 9.9 kpa and 2.9 kpa, respectively. the solution is boiled by reducing the external pressure below the vapour pressure. calculate (i) the pressure when boiling begins, (ii) the composition of each component in the vapour, and (iii) the vapour pressure when only a few drops of liquid remain. assume that the rate of vaporization is low enough for the temperature to remain constant at 20 °c.
Answers: 1
You know the right answer?
One mole of tungsten (6.02 × 1023 atoms) has a mass of 184 g, and its density is 19.3 g/cm3 , so the...
Questions
question
History, 09.10.2019 20:30
question
Biology, 09.10.2019 20:30
question
Mathematics, 09.10.2019 20:30
question
Mathematics, 09.10.2019 20:30
question
Social Studies, 09.10.2019 20:30
Questions on the website: 13722367