1) δs depends not merely on q but on . although there are many possible paths that could take a system from its initial to final state, there is always only one isothermal path between two states. thus, δs the path taken between states. options: q rev, reversible, irreversible, has only one particular value, regardless of, can have different values, which depends on, q sys2)which system has the greatest entropy? 1 mol of h2(g) at stp1 mol of h2(g) at 100∘c 0.5 atm1 mol of h2o(s) at 0∘c1 mol of h2o(l) at 25∘c3)during , the temperature but the entropy change can be large as molecules their degrees of freedom and motion. options: a phase change, remains constant, increases, heating, raises, reaction, decrease, falls

1) qrev/ reversible/ has only one particular value/ regardless of;

2) 1 mol of H₂(g) at 0ºC

3) a phase change/ remains constant/ increase

Explanation:

1) The change can occur in a reversible or an irreversible process. When the change is reversible, the system and the surroundings can be restored to their original state by exactly reversing the change. In an irreversible process, that is not possible.

The entropy variation (ΔS) is calculated only in the reversible process because, in the irreversible one, it's difficult to determine it. So, ΔS depends on qrev, which is the heat for the reversible process.

There is only one reversible isothermal path between two states, that's why it's easy to calculate ΔS for it.

The value of ΔS doesn't depend on the path, but only on the initial and the final states, so ΔS has only one particular value regardless of the path taken between states.

2) The entropy is the measure of the disorganization of a system, so when the molecules are more distant and vibrating, the entropy is higher (Sgas > Sliquid > Ssolid), and when the temperature increases, the entropy decreases (ΔS = qrev/T), so 1 mol of H₂(g) at 0ºC has the greatest entropy.

3) During a phase change, for a pure substance, the temperature remains constant, until all the substance changes for the other phase. The entropy is the measure of the disorganization of a system, so when the degrees of freedom and motion of the molecules increase, the system becomes more disorganized, so the entropy increases.

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.

every chemical equation adheres to the law of conservation of mass, which states that matter cannot be created or destroyed. therefore, there must be the same number of atoms of each element on each side of a chemical equation.