Chemistry, 14.10.2019 06:20 auviannadority13

In an experiment, 3.264 g of zinc chloride, zncl2, yielded 1.468 g of zinc metal. assuming that the original sample was pure, how much zinc should be obtained? was all zinc possible from the sample recovered? what is the calculated percentage recovery? (answer much contain proper number of significant figures).

Answers: 2

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 01:30

Follow the steps provided in the simulation to add water to the graduated cylinder, select one of the three samples (copper, silver, or gold), set its mass to the values given in the statements below, and calculate its density. here is a summary of the steps required: add water by clicking and holding prepare a known volume of water button. until the desired volume of water has been added. if more than the desired volume is added, click the reset button. button and redo the procedure. a single click will add about 21.0 ml of water. to set the mass, click and hold weigh out metal button. until the desired amount of metal is added to the weighing pan. once the desired mass of the metal is added, release the button. transfer the metal to water and then click on calculate density button. to see how the density is calculated using water displacement to measure the volume of the solid. to save time you can approximate the initial volume of water to â±1 ml and the initial mass of the solid to â±1 g. for example, if you are asked to add 23 ml of water, add between 22 ml and 24 ml. which metals in each of the following sets will have equal density? check all that apply.

Answers: 1

Answer

Chemistry, 22.06.2019 07:30

11. phosphorus-32 is radioactive and has a half life of 14 days. how much of a 124 mg sample of phosphorus-32 is present after 56 days? a) 7.75 mg b) 15.5 mg c) 31.0 mg d) 62.0 mg

Answers: 3

Answer

Chemistry, 22.06.2019 15:00

What is the most important factor in determining climates.

Answers: 1

Answer

Chemistry, 22.06.2019 20:30

Some familiar products contain some of the same types of atoms. for instance, the chemical formula for baking soda is nahco 3. the chemical formula for liquid bleach is naclo, and the chemical formula for table salt is nacl. which choice best describes why these three products have some of the same types of atoms in common?

Answers: 1

Answer

You know the right answer?

In an experiment, 3.264 g of zinc chloride, zncl2, yielded 1.468 g of zinc metal. assuming that the...

Questions