The liter is used to measure

weight
mass
volume
length

2fe + 3h2so4 -> fe2(so4)3 + 3h2

it is necessary to balance equations in order to get the proper amount of reactants as well as products in order not to make a miscalculation.

you cannot change the subscripts as that would change the substance itself. for instance, diatomic elements such as h2 only have the subscript two when a gas. another example would be so4, if you were to change the subscript, the element would no longer be sulfate.

we change the coefficients instead as that only changes the number of molecules rather than the substance itself.

hope this !

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.

i think slash and

28528289 29823282 8298232 39858