Chemistry, 13.07.2019 14:00 Lived

Igot a dent in the clothes dyer and i cant get it out what should i do its at the top and the edge of the dyer and the metal is thick asap a. what should i do to get it out

Answers: 1

Show answers

Answers

Answer from: idbcjcfkxb

Plunger

A plunger can actually be very effective when it comes to taking out small dents and dings in any type of aluminum. Use a plunger that is small and slightly damp. Simply place the plunger over the dent and press down; the suction should take hold and pull out the dent as you pull. This will work on smaller dents, but make sure that the plunger itself is at least as big as the dent.

Heat and Cold

You can also try to use a blow dryer and a lot of ice to get the dent out. First, use the blow dryer on the dent and get it as hot as possible. After you have done this, apply ice to the dent. If you do not wish to use ice, you can also used compressed air. Be sure that you hold the can upside down and make sure that it is cold enough to freeze. This may take a round or two of heat and cold to get the dent out. This could cause the dent to pop back out. This does not work in every case, but does not do any harm to the appliance if it does not work.

Touch-Up Paint

You may not be able to get around scratching some of the paint off of your appliance. The good part about this is that it is very easy to fix. You will simply need to get some touch-up paint at your local hardware or auto parts store. Simply apply the paint and allow for it to dry. Be sure that it is the same color as your appliance or you will be able to see the scratches just as well as if you had never used the paint at all.

Bang It Out

If you are able to get to the inside of the area where the dent is, then you can use a flat-ended hammer to bang it out. This is not always an easy task with washers and dryers, but if you are able to get to the other side of the dent, then this is a method that can work very well. Be sure that you start at the more shallow ends of the dent and work your way towards the deeper parts.

Answer from: Quest

yes it is balanced

Answer from: Quest

what's the

Another question on Chemistry

Chemistry, 22.06.2019 05:00

Type the letter that represents the correct location for each particle type below.

Answers: 1

Answer

Chemistry, 22.06.2019 11:40

Modern pennies are composed of zinc coated with copper. a student determines the mass of a penny to be 2.482 g and then makes several scratches in the copper coaling (to expose the underlying zinc). the student puts the scratched penny in hydrochloric acid, where the following reaction occurs between the zinc and the hcl (the copper remains undissolved): zn(s) + 2 hcl(aq) → h2(g) + zncl(aq)the student collects the hydrogen produced over water at 25 °c. the collected gas occupies a volume of 0.899 l at a total pressure of 79 j mmhg. calculate the percent zinc (by mass) in the penny. (assume that all the zn in the penny dissolves.)

Answers: 1

Answer

Chemistry, 22.06.2019 17:30

The polymer used for the nonstick surface of cooking utensils is 24.0%c and 76%f by mass. what is the empirical formula of this polymer?

Answers: 2

Answer

Chemistry, 23.06.2019 00:30

How many moles of co2 are produced during the complete combustion of 3.6 moles of c2h6

Answers: 1

Answer

You know the right answer?

Igot a dent in the clothes dyer and i cant get it out what should i do its at the top and the edge o...