This diagram represents the cell cycle. When cells leave the cell cycle, they exit during G1 phase and then enter G0 phase, a resting period. Most normal cells can leave G0 phase and reenter the cell cycle at G1 phase before entering S phase. Cancer cells are different because they cannot enter G0 phase and are likely to do which of the following? A Fail to complete S phase
B Continuous unregulated cell division
C Mutate during G phase
D Die after completing mitosis

d.

explanation:

i would say the prokaryotic cells the prokaryotic cells are less complex, are usually found only in unicellular organisms and have more limited capabilities than eukaryotic cells.

cells use diffusion to get substances in and out of themselves. that diffusion will occur across the cell membrane or the outer covering of the cell. because we are talking about the surface of the cell, surface area and volume are  important factors here. as a cell increases in size, its surface area and volume increase as well.  we call that the surface area to volume ratio (sa: vol).  but the catch is that  volume increases at a greater rate than surface  area. in other words, as a cell gets bigger, the sa: vol gets smaller. so a really small cell like bacteria is mostly cell membrane (surface) with very little contents (volume). a really big cell like an egg, is mostly insides with a super thin membrane. so what ends up happening is that the cell cannot efficiently diffuse all of the stuff it needs in/out to survive. therefore cell size is limited to about 100mm. so how do we make organisms bigger than 100mm? cells divide! by dividing and becoming multicellular, organisms are able to grow!   check out the diagrams i attached to see the effect of sa: vol. i hope this ! good luck!