Students studying potential and kinetic energy designed this experimental set-up. During the initial trial, a ball was rolled down a ramp fro the spot marked "start". The ball rolled down the ramp and then back up the other side, to the spot marked "finish", represented by letter B. The students want to determine the starting point so that the ball will rise up to the point marked by letter A. They release the ball starts at the spot marked "New start" and the ball rolls up the other side to letter A. This is a controlled experiment. All BUT ONE factor is controlled in this experiment. What is that factor?

A. ball used in trials

B. distance between ramps

C. starting point of release

D. angles of incline for ramps ***

Can someone check this?

The correct answer is D) angles of incline for the ramps

Explanation:

The only way the ball which rolled off Starting Point A will roll down an incline and then upwards to a finish point called B is if the angle of incline between A and the midpoint X (which is where the ball starts to roll back up) is steeper than the gradient between B and X.

The higher the gradient of the slope, the faster the acceleration of the ball towards point B from A and vice versa.

Cheers

when the displaced particles are perpendicular to the direction the wave travels, is called a transverse wave, whereas in longitudinal wave the displace practices are parallel to the direction of the wave.

in the given image:

first image shows - longitudinal wave

second image shows - transverse wave

third image shows - longitudinal wave

fourth image shows - longitudinal wave